iStation, $13.50

iStation is Plants personal water reservoir featured with a valve, so you can control the flow of water going to your plant even to drops, completely shut off the water.

Volume: can hold up to 2 cups of water (500ml, or 16oz)

Height: 30cm, or 12in (from top to bottom) It is made with PLA plastic.

"...small plants used 1 tablespoon [of water] per day, while large plants used slightly less than 2 tablespoons per day." (www.greenhousemag.com);

So simply fill iStation up with water, place it in the soil inside the flower pot, adjust the flow of water to intermittent single drops.

Bundle for 3 Pots ($9.12 ea.)

Get this bundle to drip Irrigate 3 Pots (4 parts, $9.12 a piece):

- 1 Scrube: to convert any plastic container into a water dispenser.

- T-Valve #1: to bring water to your first pot. - T-Valve #2: to bring water to your second pot. - i-Valve #3: to bring water to your third pot. - 4 Plugs to plug the vinyl tubes, when you need to. All the valves are individually multidirectional and adjustable, so you can adjust the flow of water going to each pot, if you need to do so. With your own 3/8" ID x 1/2" OD clear vinyl tubes you can extend, expand, or relocate the pots wherever you see fit.

Bundle for 6 Pots ($8.43 ea.)

Get this bundle for 6 pots.

All the valves are individually multidirectional and adjustable, so you can adjust the flow of water going to each pot, if you need to do so. With your own 3/8" ID x 1/2" OD clear vinyl tubes you can extend, expand, or relocate the pots wherever you see fit.

Scrube

 Our Scrubes come each with a small latex tube. Scrube allows you to convert regular containers into dispensers. It is made with PLA plastic. Designed to be inserted directly in 3/8" ID x 1/2" OD vinyl tube.

I-Valve

 Our I-Valves are made with PLA plastic. Use I-Valves to run single lines, directly inserted in 3/8" ID x 1/2" OD vinyl tubes.

Plus-Valve

 Our Plus-Valves are made with PLA plastic. Use Cross -Valves to run your water lined in 4 directions, directly inserted in 3/8" ID x 1/2" OD vinyl tubes.

T-Valve

Our T- Valves are made with PLA plastic. Use T-Valve to run your water line in three directions, directly inserted into 3/8" ID x 1/2" OD vinyl tubed.